Napoleon High Country NZ6000 Installation And Operating Instructions Manual page 13

FACE PLATE, UPPER GRILL, KEYSTONE & DOOR INSTALLATION
1
Remove the
facing template held
in place with the 12
screws shown. Dis-
card the screws and
template.
2
Mount the keystone
and upper grill to the face-
plate, as shown, using the
4 nuts supplied.
Remove the backing and place logo onto the bottom
left corner of the faceplate.
Ensure that the pressure switch actuating arm and air Ensure that the pressure switch actuating arm and air
Ensure that the pressure switch actuating arm and air Ensure that the pressure switch actuating arm and air Ensure that the pressure switch actuating arm and air
control rod, protrude through the faceplate when in- control rod, protrude through the faceplate when in- control rod, protrude through the faceplate when in- control rod, protrude through the faceplate when in- control rod, protrude through the faceplate when in-
stalled. stalled. stalled. stalled. stalled.
Remember to record your serial # in the manual for
future quick reference.
3
Secure the
faceplate to the
unit, using the 12
screws supplied.
Start all 12 screws,
then tighten evenly.
4
Left Door Handle
(fixed)
- Insert the handle shaft
through the door.
- Secure with a lock
washer, 2 flat washers
and a nut.
- Feed the handle through
the handle spacer and
into the handle shaft.
See Note #2
Note #1: You may need to move washers to the other side
of the latch to obtain sufficient door seal.
Note #2: The final angle of the left door handle should
mirror the right door handle in the closed position. Tighten
the nut to secure the left handle at the desired angle.
Right Door Handle
(operating)
- Insert the door rod through the
round hole of the latch ensuring
the flat edge of the "D" shaped
hole points towards the
hinges.
- Slide the end of the door
rod through the bushing at
the top of the door as
shown.
- Insert the handle shaft
through the door and the
latch.
-Secure with 2 flat wash-
ers and a nut.
See Note #1
- Feed the handle through
the handle spacer and into
t h e
handle
shaft.
W415-0594 / A / 02.15.07
13