Table of Contents
Advertisement
Available languages
Available languages
Electrical Requirements
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician
determine that the ground path is adequate.
Check with a qualified electrician if you are not sure whether the grill is properly grounded.
A 120-volt, 60-Hz, AC-only, 15-amp, fused electrical supply is required.
It is recommended that a separate circuit servicing only this grill be provided.
■ To avoid electrical shock, do not immerse cord or plugs in water or other liquid.
■ Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking
off parts.
■ Do not operate any outdoor cooking gas appliance with a damaged cord, damaged plug, or after the
appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
■ Do not let the cord hang over the edge of a table or touch hot surfaces.
■ Do not use an outdoor cooking appliance for purposes other than intended.
■ When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into
the outlet.
■ Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.
■ Do not remove the ground prong or use with an adapter of 2 prongs.
■ Use only extension cords with a 3 prong grounding plug rated for the power of the equipment and
approved for outdoor use with a W-A marking.
ROTISSERIE ASSEMBLY
Jenn-Air grills:
Estimated Assembly Time: Approximately 10 minutes
Required Tools: Phillips Screwdriver (not included)
1. To attach the universal bracket (G) to the motor bracket (B), align the
pre-drilled holes in both brackets and secure together using two 2-in.
bolts (H) as shown in Fig. 1.
2. Align the holes in the universal bracket (G) to the pre-drilled holes on
the left side of the grill. Attach the universal bracket using two 1/4-inch
screws with flat washer/lock washers/nut (I) as shown in Fig.2.
Note: The universal bracket may have to be adjusted once the
motor is attached and the spit rod is inserted.
3. Slide rotisserie motor (A) over motor bracket (B) as shown in Fig. 3.
Fig.1
Fig.2
Fig. 3
6
Advertisement
Table of Contents
