Door Opening & Closing; L36 Louvre Installation - Napoleon BGNV36N Installation And Operation Instructions Manual

8
DOOR OPENING & CLOSING
The upper louvres must be
removed to allow the door
to be opened or closed. To
access the lower door
latch, open the valve con-
trol door. Release the top
and bottom door latches, lo-
cated at the right side of the
door.
FIGURE 13
GVFL LOUVRE INSTALLATION
UPPER LOUVRES: Insert the
upper louvres into the slots
on both brackets. Press the
top flange of the hood into the
four clips located along the
top of the unit as shown.
FIGURE 14
LOWER LOUVRES: Attach
each hinge to the firebox with
2 screws. door and optional
louvre.
FIGURE 15
HINGE SCREEN:Position the hinge screen into place and
with the control door open, secure to the firebox using three
screws.
FIGURE 16
W415-0275 / C / 09.23.05
FINISHING
FLANGE
CLIP
UPPER LOUVRE
DOOR LATCH
HOOD
BRACKET
SLOT
LOUVRE
LOWER LOUVRES
(VALVE CONTROL DOOR)

L36 LOUVRE INSTALLATION

FIGURE 17
B
C
A
C L I P S
HOOD
Attach the hood by pressing the
top flange into the clips along
the top of the louvre opening.
F L A N G E
Secure using a screw through
the centre slot.
C E N T R E
S L O T
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
S L O T
right corners of the unit.
TA B
B
C
LOWER LOUVRES
HINGE
Insert the hinge clips into the
S L O T
C L I P
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
A