Trouble Shooting; Fault Table - Siemens HB676GB.1 Instruction Manual

Insert the intermediate panel at the bottom into the
1.
retainer and push it in firmly at the top (figure
Push both retainers downwards (figure
2.
Insert the front panel at the bottom into the retainers
3.
(figure ).
#
Close the front panel until both upper hooks are
4.
opposite the opening (figure

3Trouble shooting

If a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
If a dish does not turn out as well as you had
Note:
hoped, refer to the table section at the end of the
instruction manual, where you will find plenty of tips and
information. ~ "Tested for you in our cooking studio"
on page 26

Fault table

If an error message beginning with 'E' is shown, e.g.
E0111, switch the appliance off and then on again. If
Fault
The appliance does not work
The appliance door will not open; the
5 symbol is shown in the display
Although the appliance is switched
on, it cannot be operated; the
symbol is shown in the display
The cooking compartment does not
heat and "Demo mode on" is shown in
the display
--------
).
"
).
$
Possible cause
The fuse is faulty
Power cut
The appliance door is locked until the cooking com-
partment has cooled down.
The child lock is activated
1
The appliance is in demo mode
Press the front panel at the bottom until it clicks
5.
). audibly into place (figure
!
Open the appliance door again slightly and remove
6.
the tea towel.
Screw both screws back in on the left and right.
7.
Put the cover back in place and press on it until it
8.
clicks audibly into place (figure
Close the appliance door.
9.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
this message appears again, contact the after-sales
service.
Trouble shooting en
).
%
).
&
Information/remedial action
Check in the fuse box to make sure that the fuse for
the appliance is in working order
Check whether other kitchen appliances are working
Wait until the 5 symbol goes out
Press and hold the 1 button until the
goes out
Switch off the fuse in the fuse box and switch it back
on again after approx. 10 seconds. Switch on the
appliance and select "Demo mode off" in the settings.
1 symbol
23