Makita BFT041R Instruction Manual page 8

For LED#B
2
007917
Description Viewed color
LED#B
LED#B
007929
Note 1: Refer to a instruction manual of receiver
(accessory) RCV02 when connecting it.
Note 2: Communication distance: 10 m or less (variable
up to 10 m depending on the operation environment)
CAUTION:
Make sure that LED#B② does not light up before
•
removing a battery cartridge from the tool. If a
battery cartridge is removed while LED#B② lights
up or blinks, tools stored data will be deleted.
Adjusting the fastening torque
007920
1. LED#B1
2. LED#B2
1
1 lights up
2 blinks
Green
3 is turned off
1 lights up
2 blinks
Red
3 is turned off
1. Adjusting ring
1
2. Ring
2
Led indicator / Beeper on the tool shows the following
functions.
View and status
when the tool is connected to a receiver.
when the tool is on the step of being connected to a
receiver. (Note 1)
one of the status below
3-1 when the battery cartridge is removed from the tool.
when the tool is left idle for more than 15 minutes
3-2
with a installed battery cartridge.
when the tool is not within the transmission
3-3
distance. (Note 2)
when the tool's stored number of data reaches its
storable number of data.
when the tool's stored number of data is equal to or
smaller than its storable number of data.
when the tool has no stored data to transmit to a
receiver.
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures ring.
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
8