Installing The Monitor On The Dashboard - Sony XVM-B62 Operating Instructions Manual

When installing the
monitor on the dashboard
Be sure to connect the parking cord
(Light green) to the parking brake
switch cord. The mounting position of
the parking brake switch cord depends
on your car. Consult your car dealer or
your nearest Sony dealer for further
details.
Foot brake type
Hand brake type
Using the tap
Attach the supplied tap to the end of the
parking cord (Light green) and the
parking brake switch cord.
Tap (supplied)
Note
If the parking brake switch cord is too thin,
connect the parking cord (Light green) to
the parking brake switch cord directly
without using the tap.
8
Parking brake
switch cord
Parking brake
switch cord
Parking brake
switch cord
Parking cord
(Light green)
x
Installing the monitor on
the dashboard
You can install the monitor either on the
dashboard or behind the headrest.
Make sure the installation surface and
monitor position are suitable before
beginning installation. If you cannot
find a suitable mounting location,
consult your car dealer or your nearest
Sony dealer before installation.
Tips on the mounting
location
• Choose the mounting location of the
monitor unit carefully.
• In order to prevent rattling from the
vibration of the car, make sure that the
back or the bottom of the monitor is
touching the mounting surface when
mounting the monitor unit.
Caution on installation
Do not install the unit:
— in a hot place, subject to direct
sunlight, near a heater or in a car
with the windows closed (especially
in summer) or in an extremely cold
place.
— in a place subject to excessive dust,
moisture.
— in a place which could harm the
passenger.
— in a place which could distract the
driver.
— on a door or the ceiling.