Setting Character Attributes ([Font]/[Size]/[Width]/[Style]/[Line]/[Align]); Setting Character Attributes By Label; Setting Character Attributes By Each Line - Brother p-touch d600 User Manual

EDITING A LABEL
Setting Character Attributes ([Font]/[Size]/[Width]/
[Style]/[Line]/[Align])
You can set character attributes by label or by each line, both before and
after entering text.
„ Setting Character Attributes by Label
( ) è /
the attribute è
„ Setting Character Attributes by Each Line
1. Using /
character attribute.
2. Press (
NOTE
• ( ) displayed on the left side of the character
attribute that appears when you press (
and ( ) indicates that you are now applying
the attribute for that specific line only.
• When different attribute values are set for
each line, the value will be displayed as *****
when you press (
or , and then press (
When you change the setting on this screen and then press (
back to the text entry screen, the same change will be applied to all
lines of the label.
• When [Size] is set to [Auto], the actual printed font size depends on
the tape width, number of characters and number of input lines. Once
characters reach a minimum size, the selected font will default to a
custom font which is based on the Helsinki style. This allows labels
to print using the smallest text possible on narrow or multi‑line labels.
• The 6 point font only prints in Helsinki, no other font type.
• When [Size] is set to [Auto] and all the text is entered in uppercase,
the text is automatically adjusted to print in the largest font size
possible for each tape width. This font size is larger than the largest
font size available in the font settings for each tape width.
• If a line of text contains characters that are incompatible with the
"Justify" setting (some Arabic characters), the text is centered.
• Vertical Setting cannot apply when Arabic/Persian character is input.
18

Setting Character Attributes ([Font]/[Size]/[Width]/[Style]/[Line]/[Align])

Select an attribute
( ) or ( ) è
, move the cursor to the line where you wish to change the
) and ( ) to display the attributes.
), select an attribute using
è ( ) or (
( ) to return to the text entry screen.
) or ( ).
) è / Set a value for
)
) to go