JUKI cp-180 Instruction Manual And Parts List page 32

(2) Constant-dimension stitching pattern
OFF
2
Sewng pattern
CD
OFF
3
4) Four different kinds of stitching patterns can be performed according to the combination of ON/OFF set-
tngs of automatc reverse sttchng (for start) swtch 2 and automatc reverse sttchng (for end) swtch 3 .
5) Furthermore, the double reverse stitching mode can be specified by operating double reverse stitching (for
start) swtch 7 and double reverse sttchng (for end) swtch 8 .
6) If automatc thread trmmng swtch 6 s turned ON, the sewng machne wll automatcally perform
thread trimming after it finishes the predetermined number of stitches between C and D. (If the automatic
reverse feed sttchng (for end) s selected, the sewng machne wll automatcally perform thread trm-
ming after it finishes the automatic reverse stitching (for end) even when the automatic thread trimming
swtch s not selected.)
If automatc thread trmmng swtch 6 is turned OFF, operate the touch-back switch after the completion
of processes C and D. Then the machne runs at a low speed (sttch compensaton operaton).
Also, f the pedal s returned to ts neutral poston and depressed ts front part agan, the sewng can be
contnued regardless of the settng of number of sttches.
7) If thread trmmng prohbtng functon 9 s chosen, the machne wll stop wth the needle up wthout per-
formng thread trmmng.
8) If one-shot automatc sttchng functon !0 s chosen, the machne wll automatcally perform sewng at a
stretch, at the specified speed by depressing the front part of the pedal.
7 2
8 3 1
ON OFF ON
A A
B B
CD CD CD
B B
A A
OFF ON ON
4 5 6
) Press constant-dmenson sttchng pattern
swtch 1 on the control panel to select the
constant-dmenson sttchng pattern.
2) The constant-dmenson sttchng pattern s
selected. Now, the predetermned number of
sttches and the state of reverse sttchng func-
ton are shown on the control panel.
3) To change the number of sttches of the process-
es n the constant-dmenson sttchng pattern,
change the number of sttches for processes C
and D by operatng swtches 5 for settng the
number of sttches for processes C and D. Select
the reverse feed sttchng accordngly. To change
the number of reverse-feed sttches, operate
swtches 4 for settng the number of sttches for
processes A and B.
Adjustng range : A, B = to 9 sttches
- 6 -
!0
9
C, D = 5 to 500 sttches