Maintenance Parts - Everlast 16516696 Owner's Manual

HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback,
the reed switch should be adjusted. To adjust the
reed switch, the chain cover (36) must first be
removed.
Remove the seat post adjust knob (58), seat post
bushing (33) and seat post (28).
Remove the left pedal (27L) from the crank arm (31).
Remove the two screws (30) from each side of the tail
cover (38 ). Remove all remaining screws (30) from the
left chain cover (36L). Hold the chain cover (36) near the
back and pull it apart slightly.
Do not pull the chain cover apart at the top
or the seam may be broken.
Next, locate the sensor wire (62). Turn the pulley
until the magnet is aligned with the sensor.
Loosen, but do not remove, the screw (60).
Slide the sensor slightly towards the magnet.
Make sure that the magnet will not hit the sensor.
Retighten the screw (60). Turn the pulley for a moment.
Repeat until the console displays correct feedback.
When the sensor is correctly adjusted, reattach
the chain cover.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, the right chain cover (36R) must
first be removed.
Next, turn the nut (39) on clockwise to tighten the eye bolt
When the belt is correctly adjusted, reattach the chain
cover and the crank covers.
Customer Service 1-888-707-1880
or email customerservice@dyaco.ca

MAINTENANCE PARTS

slipping while you are pedaling,
17
Dyaco Canada Inc. © 2014
(40).