Hyundai HYBC5200 User Manual page 18

machine, immediately stop and check the machine.
6.2.8. Never let the machine run with damaged or defective parts.
6.2.9. In trimmer mode only use for trimming grasses.
6.2.10. Never raise the nylon cutting head above knee height during operation.
6.2.11. DO NOT use the machine on a slope or uneven ground or if there is the
chance of slipping or losing the stability,
6.2.12. Never over cut instead cut short lengths then lower until desired height is
achieved, as shown below.
ALWAYSSTOP MACHINE before removing grass deposits to prevent
overheating of the drive axle. Grass deposits occur when fibers of the
weed are involved around the shaft under the shield. This prevents the
shaft from cooling properly. Remove grass deposits with a screwdriver or
similar tool only when switched off the machine.
6.3. Trimming round trees.
6.3.1. Trim around tree trunks slowly making sure that the nylon cord does not
come into contact with the tree trunk.
6.3.2. Walk around the tree from left to right, and approach the grass/weeds
with the tip of the thread.
6.4. To release more nylon cutting line.
6.4.1. To release new nylon line, run the machine at full throttle and tap the
nylon cutting head on the grass.
6.4.2. The nylon cutting line releases automatically.
6.4.2.1.
6.4.3. When trimming near brick/stone walls the nylon line will wear out
quicker.
6.4.4. When trimming near brick/stone walls the nylon line will wear out quicker.
6.5. Replacing the nylon cord.
6.5.1. Turn off the engine
6.5.2. Put the brush cutter on the ground and dismantle
the nylon head.
6.5.3. Unlock the head by pressing the nylon head
unlocking tab (1) and turning locking ring (2) in an
clockwise direction.
The knife edge mounted on the shield cuts off excessive line.
Page 18