Table of Contents
Advertisement
machine.
4.6.2.
Clean the machine completely, particularly the fuel tank and the air filter.
4.6.3.
After using the appliance, all fuel should be removed.
4.6.4.
Spectators should be informed how to get the users attention, otherwise it could
cause an unsafe situation.
4.6.5.
Never touch the nylon cutting head or the metal sheet when the machine is
running.
4.6.6.
If it is necessary to replace the guard or the cutting tool, be sure that the
machine and the cutting tools have come to a standstill.
4.6.7.
The machine must be switched off before changing the working area of
the machine.
4.6.8.
If necessary, you can get the machine repaired by an authorized dealer. If
the machine is broken, do not continue using machine.
4.6.9.
When starting or during the operation of the machine, do not touch hot parts
such as the exhaust, ignition cables or the spark plug.
4.6.10.
After the engine is stopped, the exhaust will be hot. Never place the machine
in the vicinity of flammable materials (dry grass, combustible gases or
flammable liquids, etc.)
4.6.11.
Pay particular attention to the fact that the operation in the rain or
immediately after rain the ground can be slippery.
4.6.12.
If you slip or fall to the ground, release the throttle lever immediately.
4.6.13.
Before removing grass tangled in machine, stop the machine and disconnect
the spark plug cap. Before adjusting or repairing machine, make sure the
engine is stopped and the spark plug is disconnected.
4.6.14.
Make sure that you do not drop the machine or hit obstacles.
4.6.15.
When the machine is not going to be used for a long time and is going to be
stored, drain fuel from the fuel tank and the carburetor, clean the parts. Put the
machine in a safe place and make sure that the machine is completely cooled.
4.6.16.
Perform regular inspections for the safe and efficient operation of the machine.
For complete control, please contact a specialist workshop in conjunction.
4.6.17.
Keep the machine from fire or sparks.
4.6.18.
Be careful when using.
4.6.19.
There is a danger of kickback when using this machine.
4.6.19.1. Use extreme caution when using this machine with the cutting blade. A
kickback is a reaction that can occur when the rotating cutting blade
strikes an object which cannot be cut. This contact causes the cutting
blade to stop for an instant and then suddenly repel from the object taken
with accelerated force. This reaction can be violent enough that the
operator momentary loses control of the machine. A kickback can occur
without warning when the cutter encounters an unseen obstacle when
the blade is running. This is more likely in areas where it is difficult to
properly check the material/area to be cut. For easy and safe cutting, cut
the weeds from right to your left.
Page 13
Hide quick links:
Advertisement
Table of Contents
