Table of Contents
Advertisement
4.3. Installing the trimmer shield.
4.3.1.
Take shield (1) and offer it up to the shaft
(5), pass one of the fixing screws (4) through
one of the holes in the clamp (3), then into
shield (2) then loosely screw it into the
machine. Repeat process for the remaining
fixing screw.
4.3.2.
Once all three bolts are in place you can
tighten them up
4.3.3.
N.B. There are 3 bolts.
4.4. Mounting the brush cutter blade.
4.4.1.
Remove the spool (if fitted).
4.4.2.
You will need to lock the shaft using supplied tool (1) rotate shaft until it locks.
4.4.3.
Then using the supplied box spanner undo the retaining nut.
4.5. Mounting the trimmer spool.
4.5.1.
Remove the blade (if fitted).
4.5.2.
You will need to lock the shaft using supplied tool
rotate shaft until it locks as shown in 4.4 above.
4.5.3.
To attach spool place spacer (2) over shaft (1).
4.5.4.
Then screw spool (3) onto shaft (1).
4.6. Instructions for accessories.
4.6.1.
Make sure that your product is only equipped with original accessories. Only use
machine with original parts which are specified by the manufacturer. The use of any
other accessories or accessories may cause injury to the user and damaging the
Page 12
Hide quick links:
Advertisement
Table of Contents
