Brush Installation/Removal - Minuteman MC20000QP Operation And Service Manual

INSTALLATION
Brush Drive
1. Raise the scrubhead to the "UP" position by depressing the pedal (A)
downward as shown on Fig. 1.
2. Center brush (D) under the scrubhead shroud while lining up the center
hex drive hub and pressing the brush up until the brush engages on the
drive hub.
REMOVAL
1. Raise the scrubhead to the "UP" position by depressing the pedal (A) downward
as shown on Fig. 1.
2. Remove the brush (D) by stepping on the "BRUSH RELEASE PIN" on the top of
the scrubhead shroud as shown on Fig. 1 below.
BRUSH INSTALLATION - REMOVAL
Figure 1
6