Troubleshooting; Maintenance - Delta 22-610 Instruction Manual

24-3/4" (629 mm)

Hide thumbs

Table Of Contents

Table of Contents

Available languages

MACHINE USE

Follow these steps for achieving the best results.

1. True Up One Face – Feed one face of the board through a jointer, making thin cuts with each pass until the entire

surface is flat.

2. Plane to Thickness – Place the side you planed in STEP 1 face down and feed the board through the planer.

Plane until this side is flat, then plane both sides of the board until you are satisfied with the thickness. Make thin

cuts, and alternate sides with each pass. If, during the planing operation, you notice the board twisting, warping,

or bowing, repeat STEP 1 and true up one face.

3. When planing long stock, provide table extensions to support the infeed and outfeed end of the workpiece.

4. Plane with the grain only, and keep the planer table clean. Occasionally, wax the table surface to reduce friction

during the planing operation.

5. Cross-cut to Final Length – Cross-cut your workpiece to final length.

Feed the wood through the planer at different spots on the table to help eliminate uneven wear of the

knives.

OVERLOAD PROTECTION

The motor has an automatic reset overload protector. If the motor overheats for any reason, the overload protector will

shut off the motor. The motor must be turned to "OFF" and allowed to cool down before restarting.

NOTE: If the machine continually shuts off due to overloading, contact a qualified electrician to solve the problem.

For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or

call the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and

removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

LUBRICATION

1. Lubricate the four grease fittings - one of which is

shown at (A) Fig. 45 - located at the base of the

four table posts every 100 hours of operation with

an automotive type lithium grease or the equivalent.

2. As required, lubricate the four table-adjusting

screws (B) Fig. 46 with an automotive type lithium

grease or the equivalent.

3. Change the gear box oil once a year using extreme-

pressure gear oil, available from Delta in one

pint cans. The gear box drain plug is shown at

oil level indicator is shown at (A).