Table of Contents
Advertisement
B. Configuring the K-1900-8-IP Network Settings
Open the "Viking K-1700-IP Phone Programming" software on a windows PC that is connected to the same LAN as the K-1900-8-IP
Step 1.
phone to be programmed.
The window in the upper left corner of the menu will show you each K-1900-8-IP phone that is connected to that LAN. Select the unit
Step 2.
with the same MAC address shown on the label located on the top of the Ethernet connector on the K-1900-8-IP phone.
Step 3.
Click the "Connect" button. If a pop up window appears, enter the unit's security code (factory set to 845464) then click "OK".
Step 4.
The program will then read and display the K-1900-8-IP phone's IP and programming settings.
After adjusting the IP and phones settings, click the "Write" button under each column of settings to send the programming commands
Step 5.
to the connected unit.
C. Manually Resetting the Security Code to Enter Programming
Step 1.
Power down the K-1900-8-IP phone by disconnecting the LAN Cable (RJ45 plug).
Step 2.
Take the handset offhook, then reconnect the LAN Cable (RJ45 plug).
8-12 seconds after connecting the LAN Cable you should hear 2 beeps in the handset. Go back on-hook within 6 seconds and you
Step 3.
should hear 2 more beeps.
Step 4.
The security code is now reset to 845464 (factory default).
Step 5.
You can now enter programming by following the steps in section B above.
D. Manually Resetting All Network Parameters to Factory Default
Step 1. Power down the K-1900-8-IP phone by disconnecting the LAN Cable (RJ45 plug).
Step 2. Take the handset offhook, then reconnect the LAN Cable (RJ45 plug).
8-12 seconds after connecting the LAN Cable you should hear 2 beeps in the handset. 6 seconds later you should hear 4 beeps, go
Step 3.
back on-hook within *6 seconds. Unit will reset and 2 beeps will be heard in approximeately 7 seconds.
Step 4. You can now enter programming by following the steps in section B above.
*Note: if you do not go back on-hook within 6 seconds, the handset will continue to beep until back on-hook. This indicates an error and network
parameters will remain unchanged.
8
Advertisement
Table of Contents
