Viking K-1900-8-IP Product Manual page 14

9. Import/Export
The Import/Export feature is useful for backing up all the K-1900-8-IP's programming or for importing programming
when installing multiple units with a majority of the same programming.
10. Factory Default
Clicking on the "Factory Default " button in programming will reset all of the Programming Features back to their factory
default settings. Note: This command will not change or reset your IP settings.
11. Diagnostics
The Diagnostics section in the K-1900-8-IP PC Programming can be used to test the functionality of the mic, speaker,
proximity card reader, and relays.
12. Security Code
The security code allows the user/installer to program the K-1900-8-IP phone. The factory set security code is 845464.
It is recommended that the factory set security code be changed.
Note: The security code must be 6 digits and cannot include a Q or a #.
13. Access Code
The Access Code is used for remotely operating the relays (Doorstrike, Mag-Lock, etc) by calling into the unit. This
code provides basic security and only allows operation of the relays and not the ability to change any of the programming
parameters. Once entered, any of the "Remote Access Operation Commands" can be used. The code can be 1 to 6
digits in length and cannot contain a "Q" or "#". Simply call the K-1900-8-IP phone, the unit will automatically answer
the line and output one beep. You then enter the programmed 1 to 6 digit access code, 2 beeps should be heard. You
can now enter any "Remote Access Operation Commands" (see page 19).
14. Loud Ring
The Loud Ring feature can be set to one of two modes:
Disable: In the "Disable" mode the phone will not output a loud ring during an incoming call.
Enable: In the "Enable" mode the phone will output a loud ring signal out of the earpiece in a 2 seconds on, 4 seconds
off ring pattern. The call can then be answered by momentarily taking the handset off hook.
15. Ring Cadence
When "Auto Answer/Ring" on the K-1900-8-IP is set to "Loud Ring" or "Loud Ring with AGC" the Loud Ring cadence
can be programmed to one of 4 different cadences:
Normal Ring (single ring, 2 sec on 4 sec off)
Double Ring (double ring, 1 sec on .5 sec off 1 sec on 3.5 sec off)
Short-Short-Long (triple ring, .5 sec on .5 sec off .5 sec on .5 sec off 1 sec on 3 sec off)
Short-Long-Short (triple ring, .5 sec on .5 sec off 1 sec on .5 sec off .5 sec on 3 sec off)
16. Loud Ring Volume
The Loud Ring Volume can be set from 0 – 9. 1 = the lowest volume, 9 = the highest volume and 0 = disabled.
17. Phone Mode
The Phone Mode can be programmed to one of two settings: Auto Dialer or Manual Dial Phone. When set to Auto Dialer
the K-1900-8-IP will auto dial any preprogrammed phone numbers stored in the Phone Number Database when the
corresponding Speed Dial Number (example: apartment number) is entered on the unit's keypad. When set to Manual
Dial Phone the unit's auto dialing features are disabled and the unit functions as a standard VoIP speaker phone.
Pressing the call button will take the phone off hook allowing you to manually dial the phone number on the keypad.
14