Additional Information - NAD T 533 Owner's Manual

LAST CONDITION MEMORY
This player memorizes the user settings for the last disc that you have
viewed. Settings remain in memory even if you remove the disc from the
player or switch off the player. If you load a disc that has its settings
memorized, the latest stop position is automatically recalled.
SCREEN SAVER
The screen saver picture appears when you leave the DVD Player in stop
mode for about five minutes. After the Screen Saver has been engaged
for about five minutes, the DVD Player will automatically turn itself off.
VIDEO MODE SETTING DVD-V
• With certain discs, the playback picture may be flickering or Dot
Crawl is shown on straight lines. That means Vertical interpolation or
De-interlace is not perfectly matched with the disc. In this case, the
picture quality may be improved by changing the video mode.
• To change the video mode, press and hold DISP about 3 seconds
during disc playback. The new video mode number selected is
displayed on the TV screen. Check whether the video quality has
improved. If not, repeat the above procedure until picture quality is
improved.
• Video mode change sequence: MODE1 ➜ MODE2 ➜ MODE3 ➜
MODE1
• If you turn off the power, the video mode will be back to initial state
(MODE1).
DETAILED DESCRIPTIONS FOR VIDEO MODES
MODE1: The source material of the DVD video (film material or video
material) is determined from disc information.
MODE2: Suitable for playing film based content or video based material
recorded by the progressive scan method.
MODE3: Suitable for playing video based content with comparatively
little motion.
NOTE
The video mode setting only works when the Progressive Scan mode
is set to "On" in the Setup menu.
DVD-V DVD-A VCD 2.0 VCD 1.1
DVD-A VCD 2.0 VCD 1.1
Operation

ADDITIONAL INFORMATION

25