Ryobi ETMS1825 User Manual page 11

GB
FR DE ES
Weight
Gross weight
Net weight
Permissible ambient temperature for operation
Permissible temperature for transport and storage
Noise emission according to EN ISO 3744
Sound power level L
Sound power level L
Sound pressure level at operator L
Sound pressure level at operator's ear L
Effective value of weighted acceleration (vibration at handle)
Dust collector (not included in standard delivery
-Dust extraction port diameter
-Minimum air volume flow
-Minimum vacuum flow
-Minimum air speed at dust extraction port
OPERATIONMACHINE DETAILS
INSTALLATION AND TRANSPORT
CAUTION!
Do not carry the machine by the handle; the
handle is not designed to bear the entire weight
of the machine. To carry the machine, hold it on
both sides of the base (12).
Installation (Fig.14)
1. Lift the machine out of the box with the help of another
person.
2. Turn rotating table into 0° position and tighten the
miter lock.
NOTE:
If the machine is to be mounted on a workstand:Do not
install the rubber feet!
3. To install the rubber feet, carefully turn the machine
over to the right, so it is supported by the motor.
4. Fit the nut (A3) into the hole on the bottom of the
rubber foot.
5. Insert the Allen head screw (A1) into the machine's
foot from the top. Attach the rubber foot (A2) with the
previously inserted nut (A3) to the screw.
6. Tighten the rubber foot hand-tight only.
IT NL PT DK SE
WA
without load
WA
PA
PA
(Fig.6-Fig.13
FI NO RU PL CZ
English
SPECIFICATIONS
without load
) 7. Tighten screw with the Allen key hand-tight only.
DANGER!
Risk of injury by incorrect handling when lifting
the machine or turning the machine over. Always
hold machine at the base (12).
8. Place machine on a suitable surface:
- All four feet must firmly rest on the surface.
- The ideal height for the surface is approx.800mm.
- The saw must stand securely, even when cutting
larger work pieces.
9. Keep the packaging for future use, or separate by
material and dispose of in an environmentally friendly
manner.
Transport (Fig.5, 12, 13)
1. Place the lower blade guard (14) from the left hand
side in front of the kerf plate's rear end and push
towards the rear.
2. Swing sawhead down and engage the lock down pin (22).
3. Place the rip fence over the blade guard and secure
in position.
4. Lift the machine by holding it on both sides of the
base(12).
4
HU RO LV LT EE
kg
kg
°C
°C
dB(A)
dB(A)
dB(A)
dB(A)
2
m/s
mm
3
m /h
Pa
m/s
HR SI SK GR TR
24
19
0 to + 40
0 to + 40
103.2
97.7
91.7
88.1
<2.5
43
550
740
20