TuffStuff CFM-550 Owner's Manual page 16

FIG. 52 Next, insert one Foot Roll Tube 1 X 16 (#18)
cle located on the Bench Press Adj. Seat Frame
other Foot Roll Tube 1 X 16 (#18)
Extension Arm (#8). Next, insert the
into the receptacle located on the
as shown above. Be sure all these tubes are centered at the receptacles
from end-to-end.
FIG. 54 Secure the Foot Roll Tube 1 X 23-3/4 (#19)
Back Pad Bracket (#12) using a Set Screw 1/4-20 X 1/4 (#43). Use the
supplied Hex Key 1/8" (#86) for securing the Set Screw 1/4-20 X 1/4 (#43)
into the threaded socket located on the
(#12).
Note: Refer to Fig. 68 on page 19 for further illustration of this
assembly. In addition, a measuring tape is used to center the
Roll Tube 1 X 23-3/4 (#19). The measurement from one end of the
tube to the receptacle, as pictured above, should be about 10-1/2".
15
into the recepta-
(#9). Then, insert the
into the receptacle located on the
Foot Roll Tube 1 X 23-3/4 (#19)
Adjustable Back Pad Bracket
to the Adjustable
Adjustable Back Pad Bracket
FIG. 53 Secure the
Adj. Seat Frame (#9)
Leg supplied Hex Key 1/8" (#86) for securing the Set Screw 1/4-20 X 1/4 (#43)
into the threaded socket located on the
(#12), (#9).
Note: Refer to Fig. 67 on page 19 for further illustration of this
assembly.
FIG. 55 insert one Foam Foot Roll 7 X 4 X 1 (#46) onto each end of
the three Foot Roll
Diagram on page 21 for further clarification of this assembly.
Foot
Foot Roll Tube 1 X 16 (#18)
using a Set Screw 1/4-20 X 1/4 (#43). Use the
Bench Press Adj. Seat Frame
Tubes, as shown above. Refer to the Exploded View
CFM-550 Compact Frontal Machine
to the Bench Press