Table of Contents
Advertisement
46
Removal
34. ODOMETER TAKE-OFF
Remove the bolt (A/F-68-69) and disconnect from the general wiring (B/F-70).
To disconnect the take-off, tilt the front headlight holder.
B
ATTENTION: the distance between the bolts on the disks and the sensor must be bet-
ween 1 and 2 mm. Washers (C/F -71) are fitted to achieve this distance.
If this distance is not maintained, the sensor will give incorrect values.
MRT SM
A
F-68
F-70
Chassis
MRT
A
C
distance < 1mm
F-69
F-71
Advertisement
Table of Contents
Need help?
Do you have a question about the MRT 50 and is the answer not in the manual?