Table of Contents
Advertisement
Spark Arrester
WARNING
Failure to heed the following warnings while servicing the spark arrester could result in serious injury or
death.
Do not perform service on the spark arrester while the system is hot. Exhaust system temperatures can
reach 1000° F. Allow components to cool sufficiently before proceeding.
Remove any combustible materials from the area.
Wear eye protection and gloves.
Do not stand behind or in front of the vehicle while purging.
Never run the engine in an enclosed area. Exhaust can cause loss of consciousness or death in a very
short time.
Never go under the vehicle while it's inclined.
Use the following procedure to periodically purge accumulated carbon from the exhaust
pipe.
1. Remove the arrester clean-out plug located on the bot-
tom of the muffler.
2. Place the transmission in neutral. Engage the park
brake. Start the engine.
3. Purge accumulated carbon from the system by momen-
tarily revving the engine several times.
4. If carbon is expelled, partially cover the exhaust outlet
and rap on the pipe around the clean-out plug while
revving the engine several more times.
5. If particles are still suspected to be in the muffler, ele-
vate the rear of the vehicle one foot higher than the
front. Block the wheels.
6. Repeat steps 3 and 4 until no more particles are expelled when the engine is revved.
7. Stop the engine. Allow the arrester to cool.
8. Reinstall the arrester plug and remove the partial outlet cover.
MAINTENANCE
Exhaust
Outlet
Clean-Out
Plug
65
Hide quick links:
Advertisement
Table of Contents
