Polaris RANGER Diesel 2013 Owner's Manual For Maintenance And Safety page 28

FEATURES AND CONTROLS
Seat Removal
Pull up on the front of the seat and slide it toward the front of the vehicle. Install the seat by
sliding the tabs into the rear of the seat base. Push down firmly on the front of the seat until
the pins are fully seated into the grommets.
Seat Belts
This POLARIS vehicle is equipped with three-point lap
and diagonal seat belts on all external seats.The center
seat is equipped with a lap-style seat belt. Always make
sure the seat belts are secured for all riders before operat-
ing.
WARNING! Falling from a moving vehicle could result in
serious injury or death. Always fasten your seat belt securely
before operating or riding in the RANGER.
To wear the seat belt properly, follow this procedure:
1. For 3-point belts, pull the seat belt latch downward
and across your chest toward the buckle at the inner
edge of the seat. The belt should fit snugly across
your hips and diagonally across your chest. Make
sure the belt is not twisted. For lap style belts, place
the belt across your lap as low on your hips as possi-
ble. Make sure that the belt is not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.
Tip: The center belt must be tightened manually by pulling on
the strap.
4. To release the seat belt, press the square red button in
the buckle's center.
24
Latch Plate
Buckle