Panasonic Sectlon 770 Technical Manual page 12

Section 770 Voice Recognition Telephone
NAME TO ADD ?
PHONE NUMBER ?
SPEECH TOO LONG
BAD TRAINING
REPHRASE
YES
04593972_
BS COMPLETE
12
Note: Do not insert any pauses between, for example, given name
and surname. If you do insert a pause, the words may not be
recognized as a single name.
Example: To record "Panasonic"
#2
Say "Panasonic."
it again."
7. Repeat the name of the person or company, etc., for which you
are making an entry in the Phonebook.
Voice Guidance responds with "Enter phone number."
Note: Be sure to use the same tone of voice, etc., as used in step 6.
Example: Say "Panasonic".
"Enter phone number."
• If the name is too long
The following message is displayed and Voice Guidance
responds with "Try again." Repeat the procedure from step 5
making the name shorter. (The maximum recording time per
entry is 2.5 seconds.)
• If the tone used in step 6 differs from that used in step 7
The following message is displayed and Voice Guidance
responds with "Try again." Repeat the procedure from step 5.
• If the recorded name sounds close to an existing entry
The following message is displayed and Voice Guidance
responds with "'Existing name' Conflict. Try again." Say "Yes"
to return to step 5. Create the entry using a different name.
8. Use the Telephone number buttons to enter the telephone
number to be recorded for that entry. If you are dialing an
outside line and need a pause, use the REDIAL button.
Notes: • When storing an exchange line telephone number, you
must include the following:
• Specified exchange line Nos: 88nn(n) where nn(n) is
the exchange line No. 01 to 99 or 001 to 576.
• Optional station selection Nos.: 81 to 84, and 9
• Enter Pause (REDIAL Key) in front of the Telephone
number.
• You cannot speak the Telephone number.
(USA) issued April 2000
Chapter 2. Adding a Phonebook Entry
Voice Guidance responds with "Say
Voice Guidance responds with
DBS/824-770