Pride QUANTUM 1650 Owner's Manual page 26

V . C O M F O R T A D J U S T M E N T S
Controller Position Adjustment
You can position the controller for either left-hand or
right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To change the controller position:
1. Unplug the controller harness from the back of the
controller.
2. Cut the wire tie(s) that attaches the controller
harness to the armrest.
3. Loosen the setscrews on the controller mount. See
figure 14.
4. Slide the controller out of the armrest.
5. Remove the controller mount.
6. Reinstall the controller mount onto the other
armrest.
7. Slide the controller into the controller mount.
Tighten the setscrews to secure the controller.
8. Use a wire tie to secure the controller harness to the
armrest.
9. Plug the controller harness back into the controller.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different
heights in 1.75-cm (0.5-in.) increments.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform
bracket. See figure 15.
2. Raise or lower the foot platform to the desired
height.
3. Reinstall the hardware into the foot platform
bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex
key. See figure 15.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrews.
2. Turn the setscrews to raise or lower the front of the
foot platform.
26
Figure 14. Controller Mount
HARDWARE
Figure 15. Foot Platform Adjustment
www.pridemobility.com
SETSCREWS
SETSCREWS
Quantum 1650