Rubine IA series Operation Manual
Instant water heater
Hide thumbs
Also See for IA series:
- Operation manual (11 pages) ,
- User manual (17 pages) ,
- User manual (17 pages)
Related Manuals for Rubine IA series
Summary of Contents for Rubine IA series
- Page 2 Do not install the heater where there is consistent spray directly over the unit. Do not attempt to repair the heater without qualified technician. Test water temperature with hand before using the shower. 11. Do not leave the hand shower idle in the pail.
- Page 3 (For Inverter Silent Pump Model & AC Pump Model Only) (Model IA9100DC – Inverter Silent Pump) (Model IA9200AC – AC Pump)
- Page 4 45mm 19 mm 2. CHROME ACCESSORIES 35 mm 32 mm 32 mm 65mm...
- Page 5 3. RAIN SHOWER SET Water Saver Chip Water Saver Chip Tighten the Slide down and hook assembled divider to mounted square bracket STEP 1 STEP 2 Do marking for the location of the lower square and upper There is two Water Saver Chips located round bracket.
- Page 6 - optional...
- Page 7 2. INLET and OUTLET connection of the heater unit should not be reversed, with stop valve installed on INLET. (Diagram 1) INLET (Diagram 3) a) Connect the stop valve to INLET, and be sure to put a gasket to prevent water leakage, SAFETY PRECAUTION Do not install reverse INLET and OUTLET of heater Diagram 3...
- Page 8 Restore cover c) Restore the cover and secure screw at the bottom. (Diagram 4) (Diagram 5) Diagram 4 STEP 1 STEP 2 Diagram 5...
- Page 10 (Diagram 6) Remove the filter mesh at the stop valve (for filter type only) by turning the knob filter counter clockwise direction and pull out the knob (Diagram 6). Flush it with water to remove any trapped sediments. Install the knob filter back to its original position. stop valve CLEAN REGULARLY...
- Page 11 INVERTER SILENT PUMP (IA951D) NON-PUMP (IA950N)
- Page 12 AC PUMP (IA952A)
Need help?
Do you have a question about the IA series and is the answer not in the manual?
Questions and answers