Page 2
Do not install the heater where there is consistent spray directly over the unit. Do not attempt to repair the heater without qualified technician. Test water temperature with hand before using the shower. 11. Do not leave the hand shower idle in the pail. TEST RESET...
Page 3
PUMP (For Inverter Silent Pump Model & AC Pump Model Only) HEATER TEST RESET Alternative Cable Entry...
Page 4
1. WHITE ACCESSORIES 45mm 19 mm 2. CHROME ACCESSORIES 35 mm 32 mm 32 mm 65mm...
Page 5
3. RAIN SHOWER SET Water Saver Chip Water Saver Chip Tighten the Slide down and hook assembled divider to mounted square bracket STEP 1 STEP 2 Do marking for the location of the lower square and upper There is two Water Saver Chips located round bracket.
Page 7
2. INLET and OUTLET connection of the heater unit should not be reversed, with stop valve installed on INLET. (Diagram 1) TEST RESET stop valve incoming water INLET OUTLET (Diagram 3) a) Connect the stop valve to INLET, and be sure to put a gasket to prevent water leakage, SAFETY PRECAUTION Do not install reverse INLET and OUTLET of heater...
Page 8
Restore cover c) Restore the cover and secure screw at the bottom. (Diagram 4) (Diagram 5) Diagram 4 STEP 1 STEP 2 Diagram 5 b) Switch on the main power supply (“POWER” LED would light up). Press ‘RESET’ button. The unit should resume to normal condition.
Page 9
Switch on the main power supply, the ‘POWER’ LED would light up. Switch off the power supply when not in use. (Diagram 6) Remove the filter mesh at the stop valve (for filter type only) by turning the knob filter counter clockwise direction and pull out the knob (Diagram 6).
Page 10
440(H) x 190(W) x 75(D) AC Pump 2.0kg INVERTER SILENT PUMP (SSE851D)
Need help?
Do you have a question about the SSE series and is the answer not in the manual?
Questions and answers