Speaker Connector Installation; Hardware Reset Switch Connector Installation; Green Function Installation; Peripheral Device Installation - Gigabyte GA-5SMM User Manual

Hardware Installation

3.8. SPEAKER CONNECTOR INSTALLATION

There is a speaker in AT system for sound purpose. The 4 - Pins connector SPK is
used to connect speaker. The speaker can work well in both direction of connector
when it is installed to the connector SPK on mainboard.

3.9. HARDWARE RESET SWITCH CONNECTOR INSTALLATION

The RESET switch on panel provides users with HARDWARE RESET function which
is almost the same as power-on/off. The system will do a cold start after the RESET
switch is pushed and released by user. The RESET switch is a 2 PIN connector and
should be installed to RE on mainboard.

3.10. GREEN FUNCTION INSTALLATION

There is one jumper for the purpose of power saving, GN, to indicate the power
saving function . If the GD is lighted on, the system is in green mode. The GN switch
will force the system into green mode .

3.11. PERIPHERAL DEVICE INSTALLATION

After installation of the device and setup of the jumpers, the mainboard can be
mounted into the case and fixed by screw. To complete the mainboard installation,
the peripheral devices could be installed now. The basic system needs a display
interface card and a storage device.
If a PCI - Bus device is to be installed in the system, any one of three PCI - Bus slots
can be used for Slave or Master PCI - Bus device.
After installing the peripheral device, the user should check everything again and
prepare to power-on the system.
3-9