Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ASUSTOR AS50 Series
Summary of Contents for ASUSTOR AS50 Series
- Page 1 Memory Installation Guide For ASUSTOR AS5 Series NAS Ver.1.0.1.0224...
-
Page 2: Table Of Contents
Parts and Tools Needed ..................4 Installation Guide ....................5 2.1. Removing the Cover ..................5 2.2. Installing Memory .................... 6 2.3. Replacing the Cover ..................8 Appendix ......................10 3.1. Troubleshooting ..................... 10 3.2. Contact ASUSTOR Technical Support ..............10 Page 2 of 10... -
Page 3: Introduction
ASUSTOR NAS Memory Installation Guide 1.1. Notes and Precautions All AS50 and AS51 Series NAS devices support up to 8GB of memory. Before adding or removing memory modules, please read the following precautions thoroughly. Your NAS and memory modules use high precision components and electronic connector •... -
Page 4: Parts And Tools Needed
Be careful not to injure your hands or fingers with sharp edges of the memory module, • inner components, or circuit boards of your NAS. ASUSTOR does not guarantee that third party memory modules will work in your NAS. • Be sure to turn off your NAS and peripherals and disconnect all attachments and •... -
Page 5: Installation Guide
ASUSTOR NAS Memory Installation Guide 2.1. Removing the Cover Shutdown the NAS by selecting [Shut down] from the ADM User Menu. • Disconnect all cables and devices connected to the NAS including the power cord. • Use a screwdriver to loosen the three screws found on the rear of the NAS as shown •... -
Page 6: Installing Memory
ASUSTOR NAS Memory Installation Guide • Grip the cover from both sides with two hands and then gently push it back to remove it from the chassis. 2.2. Installing Memory Note: When installing a single memory module, please ensure that it is the same size as the built-in memory module (1GB/2GB). - Page 7 ASUSTOR NAS Memory Installation Guide • Using two fingers, carefully push down and then back on the memory module until it clicks into place. You should be able to hear an audible “click”. To install the second memory module, continue with the steps outlined below.
-
Page 8: Replacing The Cover
ASUSTOR NAS Memory Installation Guide • When inserting the memory module into the empty slot, please make sure to align the notches on the module with the notches in the slot. Diagonally slide in the memory module (as shown in the illustration) making sure that the memory module’s connectors are fully inserted into the slot. - Page 9 ASUSTOR NAS Memory Installation Guide Page 9 of 10...
-
Page 10: Appendix
ASUSTOR NAS Memory Installation Guide 3.1. Troubleshooting Q: After installing new memory my NAS won’t start. What’s wrong? A: Please follow the steps below to resolve this issue: 1. Check if the LED indicators, system buzzer, and LCD display panel are operating normally.
Need help?
Do you have a question about the AS50 Series and is the answer not in the manual?
Questions and answers