Panasonic TY-WK42PV7 Installation Instructions Manual page 5

3. Prepare the Plasma Display.
Attach the insulating spacers to the display.
Remove the four bolts.
For 58-inch:
Caps
4. Install the display to the wall-hanging bracket.
Horizontal installation
Vertical installation
Top notches
(For horizontal installation)
Bottom notches
(For horizontal installation)
Insulating spacer
Top notches
(For vertical installation)
Bottom notches
(For verticalinstallation)
Insulating spacer
1. Place the display face down on top of a cloth
which is clean and free from other foreign
particles, and then carry out the procedure
below.
2. Remove the four bolts from the display.
(For 58-inch : Using a flathead screwdriver,
remove the four caps from the plasma display.)
3. Use the accessory tool (Allen key) to install the
four accessory pan head bolts with hex socket,
toothed pan washers and insulating spacers into
the holes where the four bolts or caps used to be
as shown in the illustration.
Pan head bolt with hex socket
Toothed pan washer
Insulating spacer
Allen key
Push the upper insulating spacers on
the display into the notches at the top
of the wall-hanging bracket until they
are hooked in, and then lower the
display into place.
While lifting the display slightly, insert
the lower insulating spacers on the
display into the lower horizontal
hanging holes in the wall-hanging
bracket, and then lower the display.
CAUTION
• Do not lift the display too high, otherwise it
may become unhooked.
11