Indoor Unit Installation - Daikin FTXG25EV1BS Installation Manual

Indoor Unit Installation

1.
Installing the mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring
points on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and Dimensions
Recommended mounting plate
retention spots (6 spots in all)
110
48 150
Through-the-wall hole
Drain hose position
* The removed pipe port cover can be
kept in the mounting plate pocket
2.
Boring a wall hole and installing wall embedded pipe
• For walls containing metal frame or metal board, be sure to use a wall
embedded pipe and wall cover in the feed-through hole to prevent possible
heat, electrical shock, or fire.
• Be sure to caulk the gaps around the pipes with caulking material to prevent
water leakage.
1) Bore a feed-through hole of 65mm in the wall so it has a down slope
toward the outside.
2) Insert a wall pipe into the hole.
3) Insert a wall cover into wall pipe.
4) After completing refrigerant piping, wiring, and drain piping, caulk pipe
hole gap with putty.
IEnglish
840
(Bolt size : M10)
190
182 35
Removed pipe
port cover
A
Mounting
plate
Leveling mounting plate
Dangle a weighted thread and
a
align thread with vertical arrow.
b Place a leveler on raised tab.
260
(Bolt size : M10)
170
Unit outline
Gas pipe end
Liquid pipe end 100
Secure the installation plate to the wall on
the side where the bottom frame and the
installation plate are secured to each other.
Use tape measure
as shown.
Position the end of
tape measure at ∇.
60
(unit: mm)
Inside Outside
Wall embedded pipe
(Field supply)
Caulking
Wall hole cover
(Field supply)
Wall embedded pipe
(Field supply)
6