Panasonic BL-C10 Installation & Troubleshooting Manual page 24

Installation/Troubleshooting
Problem
Brightness is
not adjusted for
about half a
minute.
The image
refreshes very
slowly.
The Update
Firmware page
is displayed
when accessing
the camera.
24
• Brightness may not be adjusted for about half a minute, if the
brightness changes sharply.
Locate the camera where the brightness does not change
sharply.
• In very low light it is normal to see random colored noise on the
image.
As the light increases this will improve.
• Multiple users are accessing the camera.
If multiple users are accessing the camera, the image
refreshes slowly.
• You are not using an Ethernet switching hub.
If you view multiple cameras on the Multi-Camera page, the
image refreshes slowly. Use an Ethernet switching hub.
• The image may refresh slowly, depending on image resolution,
image quality, network traffic, PC performance or what object
you view.
• The Max. bandwidth usage is limited.
Increase the max. bandwidth usage on your network (see
page 29 of the Operating Instructions in the Setup CD-ROM).
• The camera is in color night view mode.
The image refreshes slowly in color night view mode. Make
the area around the camera brighter.
• The camera firmware may be broken because the power was
turned off during the update, etc.
Download the latest firmware from the Panasonic Network
Camera support website and update the firmware.
Cause and Remedy
Troubleshooting