Care And Cleaning - Electrolux ESF2430 User Manual

Setting and starting a washing
programme with delay start
1. Set a washing programme.
2. Press the delay start button.
– The delay start indicator light comes
on.
3. Press the start/cancel button.
– The countdown of the delay start
starts.
– The phase indicator lights go off.
When the countdown is completed, the
washing programme automatically starts.
• The delay start indicator light goes off.
• The phase indicator light comes on.
Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.
Cancelling a delay start:
1. Press and hold the start/cancel button
for approximately 5 seconds.
– The start/cancel indicator light and
delay start indicator light go off.
– The phase indicator lights start to
flash.

CARE AND CLEANING

Warning! Switch the appliance off
before you clean the filters.
Cleaning the filters
Caution! Do not use the appliance
without filters. Make sure that the
installation of the filters is correct.
Incorrect installation will cause
unsatisfactory washing results and
damage to the appliance.
The dishwasher has 2 filters:
1. microfilter
2. flat filter
2. Press the start/cancel button to start
the washing programme.
End of the washing programme
Switch off the appliance in these condi-
tions:
• The appliance stops automatically.
• The end indicator light comes on.
For better drying results, keep the door ajar
for some minutes before you remove the
dishes.
Let the dishes cool down before you re-
move them from the appliance. Hot dishes
are easily damaged.
Do these steps to clean the filters:
1. Open the door.
2. Remove the basket.
3. Remove the filters in the bottom of the
appliance.
4. Clean the filters below running water.
electrolux 11