6 6
Appliance Preparation
A. Vent Collar Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
Top Vent
•
Remove the cover plate by removing the four screws
holding it to the top of the appliance. Remove and
discard the cover plate.
Figure 6.1
•
Remove the center insulation plug.
Figure 6.2
•
Cut the metal retaining band and fold the sides out.
Figure 6.3
30
Heatilator • NEVO3630I-B, NEVO4236I-B Installation Manual • 2378-980 Rev. E • 4/16
•
Fold the center parts of the retaining band up and use
to remove the vent cap.
Figure 6.4
•
Discard the vent cap, remove and discard the insulation
basket.
Note: Once the vent cap has been removed it cannot be
reattached.
Figure 6.5
• Remove the insulation from the outer vent pipe. For
rear venting there is no insulation in the outer vent pipe.
Figure 6.6
•
Snap the fi rst vent section into place.