Intel D875PBZ Quick Reference page 15

Delete RAID Volume
CAUTION
All data on the RAID drives will be lost.
1. Select option 2 Delete RAID Volume and press the <Enter> key to
delete the RAID set.
2. Press the <Delete> key to delete the RAID volume. Confirm the
volume deletion by pressing the <Y> key.
Reset RAID Data
CAUTION
All data on the RAID drives and any RAID structures will be lost.
1. Select option 3 Reset RAID Data and press the <Enter> key to delete
the RAID set and remove any RAID structures from the drives.
2. Confirm the selection by pressing the <Y> key.
®
Loading the Intel Application Accelerator 3.0 RAID Edition Driver
For Microsoft Windows XP, follow these steps to install the RAID driver:
1. As Windows Setup begins, press <F6> to specify the RAID driver.
2. When queried by the installation screen, press <S> to specify an additional
device.
3. Insert the floppy disk labeled Intel
Edition Driver and press <Enter>.
4. Press <Enter> to select the Intel RAID controller.
5. Press <Enter> to continue with Windows Setup.
Configuring an Intel RAID Ready System
The Intel Application Accelerator 3.0 RAID Edition software offers the
flexibility to upgrade from a single Serial ATA drive to a two drive RAID 0
configuration when an additional Serial ATA drive is added to the system.
However, several important steps must be followed at the time the system is first
configured in order to take advantage of RAID when upgrading to a second
Serial ATA drive.
1. The BIOS must be configured for RAID before installing Windows XP on
the single Serial ATA drive. Refer to section 'Configuring the BIOS for
Intel RAID Technology for Serial ATA' on page 14 to properly configure
the BIOS.
2. Install the Intel RAID driver during Window Setup. Refer to section
"Loading the Intel Application Accelerator 3.0 RAID Edition Driver" to
install the driver during Windows Setup.
Intel Desktop Board D875PBZ Quick Reference
®
Application Accelerator 3.0 RAID
15