Punch & die service life
Replace or sharpen punch and die after cutting the
lengths indicated in the accompanying table. Their life,
of course, depends upon the thickness of materials cut
and lubrication conditions.
Punch
Replace after 150 m of 3.2 mm steel sheet
Die
Sharpen after 300 m of 3.2 mm steel sheet
006441
When cutting is poor even after replacing the punch,
sharpen the die. Grind down the dull edge shown in the
figure using a grinder. After rough-grinding the dull
portion, finish with a dressing stone. Stock removal
should be about 0.3 to 0.4 mm.
Fig.9
When installing ground die, a clearance of 3.5 to 4.0
mm should be obtained by attaching one or two of the
washer provided, as shown in the figure. Failure to have
the proper clearance will result in vibration during
cutting.
Fig.10
CAUTION:
Secure installing screws carefully when installing.
•
A loose screw can cause tool breakage during
operation.
NOTE:
The die can be sharpened two times. After two
•
sharpenings, it should be replaced with new one.
Replacing carbon brushes
Fig.11
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.12
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
or
attachments
Only use
accessory or
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Die
•
Punch
•
Hex wrench
•
Wrench 50
•
Die height adjustment washer
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
are
6