Instructions For Power - Comfort Glow ES4840 Installation Instructions And Homeowner's Manual

The concept of Zone Heating is simple. Use High Efficiency heaters to heat the rooms you use most, during the
times you use these areas and turn back the thermostat to your central heating system. To achieve the
maximum benefit it is important to understand your heater and where best to locate it.
Please follow these suggestions:
1. Close doors to areas you do not wish to heat.
2. Locate a three prong outlet along an interior wall if possible. Position the heater so that the warm air
can blow unobstructed across the room towards the exterior walls.
3. Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss.
Rapid heat loss will minimize the effectiveness of your heater as it would any conventional type heater.
4. Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical
cords, drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater
and away from the sides.
5. Avoid locating your heater in high traffic areas or in direct sunlight.
6. Avoid locating your heater near your central heating thermostat.
WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do
not only turn off heater from the main "ON/OFF" switch, be sure to unplug this heater.
Note: The power cord has a polarized plug (with one blade wider than the other) that will only fit in a
polarized outlet one way. If it does not insert easily try reversing the plug. If it still does not fit contact your
electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60Hz circuit with a
properly grounded outlet is required.
Preferably, the heater will be on a dedicated
circuit. Other appliances on the same circuit
may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation.
The unit comes standard with a 6' (1828mm)
long three wire cord exiting from the rear of
the appliance.
ZONE HEATING SAVES!

INSTRUCTIONS FOR POWER

~ 4 ~
WARNING: Electrical
outlet wiring must comply with
local building codes and all
other applicable regulations to
reduce the risk of fire, electrical
shock and injury.
WARNING: Do not use this
appliance if any part of it has
been under water. Immediately
call a qualified service technician
to inspect the appliance and
replace any part of the electrical
system if necessary.