Assembly And Use For The Bowl - Ninja Ultima BL820NZ Owner's Manual

Assembly and Use for the Bowl

WARNING: Never leave the appliance unattended while in use.
ASSEMBLY
Fig. 14
Fig. 15
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry, level
surface such as a counter or table top.
2 Align and lower the Bowl onto the motor
base. (Fig. 14) Handle should be aligned
slightly to the right of the "LOCK" symbol on
the motor base.
3 Rotate the bowl clockwise as far as it will go
to lock in place. (Fig. 15)
4 The bowl can be placed on the motor base
two ways; the handle can be on the front right
corner or the front left corner.
(Fig. 16a, Fig. 16b)
5 Holding the desired blade by the top of the
shaft, place it onto the drive gear inside the
bowl. Ensure that the attachment is seated
properly and is standing upright. (Fig. 17)
NOTE: The blade will fit loosely on the star-
shaped post.
11 CUSTOMER CARE - NZ: 0800 002 999
Fig. 16a
Fig. 16b
6 Add the ingredients to the bowl, making sure
that they do not exceed the highest measured
marking line on the side of the bowl.
7 Holding the lid from the feed chute, place
it on top of the bowl and turn clockwise
aligning the arrow ( ) located on the lid with
the arrow ( ) located on the bowl's handle.
(Fig. 18)
8 Plug the power cord into the electrical outlet
and press up on the power toggle ( ) to turn
the power "On".
NOTE: The bowl is not intended for
blending drinks. Do not exceed the "Max
Fill" mark on the bowl.
NOTE: To add liquids during
processing, remove the food
pusher from the feed chute to
drizzle in liquids. Do not remove
the lid while in use.
TIP: Turn the unit down to the
lowest setting before adding
additional liquids.
Fig. 17
Fig. 18