Assembly And Use For The 1 L Bowl - Ninja Kitchen System Pulse BL201C Owner's Manual

Assembly and Use for the 1 L Bowl

ASSEMBLY
Shaft
Or
Fig. 1 Fig. 2
IMPORTANT: Make sure that the motor base is plugged in
for use.
1 Place the motor base on a clean, dry, level surface such as
a counter or table top.
2 Align and lower the bowl onto the motor base. (Fig. 1)
Handle should be aligned slightly to the left of the "LOCK"
symbol on the motor base.
3 Rotate the container to the left as far as it will go to lock in
place. (Fig. 1)
4
Holding the desired attachment by the shaft, place it onto the
drive gear inside the container. Ensure that the attachment is
seated properly and is standing upright.(Fig. 2)
NOTE: The blade will fit loosely on the drive gear.
5
Add the ingredients to the bowl, making sure that they do
not exceed the highest measured marking line on the side
of the bowl.
6
Holding the lid by the handle in the upright position, place it
on top of the bowl aligning the arrow ( ) located on the lid
with the arrow ( ) located on the bowl's handle. (Fig. 3)
12 1-877-646-5288
Fig. 3
Fig. 4
It's best to add the liquid ingredients first and then the dry ingredients.
PULSE
7 Push down on the "PULSE" on the handle to start the
appliance. (Fig. 4)
NOTE: Pulse ingredients for even chopping by pressing
down in short intervals.
IMPORTANT: When using the dough blade or cookie
paddle hold the appliance to secure the appliance to the
counter or table top.
8
When you have reached your desired consistency, stop
pressing the lid handle and wait for the attachment to stop
turning.
9 To remove the lid, pull the lid handle up to a 90° angle. Turn
the bowl clockwise to lift off the base. (Fig. 5, Fig. 6)
CAUTION: Never insert your hands in the pitcher as the
blades are sharp. Always use a spatula to dislodge food that
has stuck to the sides of the pitcher.
10 Make sure that the unit is unplugged when not in use.
REMOVAL
Fig. 5 Fig. 6