Assembly And Use For The Single Serve Cup - Ninja Ultima BL820NZ Owner's Manual

Assembly and Use for the Single Serve Cup

ASSEMBLY
Fig. 9 Fig. 10
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry, level
surface such as a counter or table top.
2 Add ingredients to the single serve cup.
NOTE: Do not overfill! Do not exceed "Max
Fill" mark on the cup.
3 Place the single serve blade onto the cup and
screw it on tightly until you have a good seal.
(Fig. 9)
4 Turn the single serve cup upside down and
place it onto the motor base, aligning the tabs
on the cup with the motor base. (Fig. 10)
Turn clockwise until the cup locks in place,
the unit is ready for use. (Fig. 11)
5 The single serve cup only operates at one
speed regardless of which number is chosen
on the dial. Press down on the "Start/Stop/
Pulse" toggle in short intervals until you have
reached your desired consistency. (Fig. 11)
Fig. 11
For best results, use short "PULSES"... Practise makes perfect!!
PULSE
Fig. 12
6 When you have reached your desired
consistency, turn the single serve cup counter-
clockwise (Fig. 12) and pull straight up to
remove. (Fig. 13)
7 Turn the cup upright and remove the single
serve blade by twisting the blade assembly
counter clockwise.
8 Place the Sip & Seal
the single serve drink cup, screw on to seal
and enjoy!
9 Make sure that the motor base is unplugged
when not in use.
CUSTOMER CARE - AU: 1800 890 840
REMOVAL
Fig. 13
To-Go drinking lid onto
™
10