Page 1
7300 Series Operating Manual Genelec 7382A Smart Active Subwoofer...
Page 2
The GLM software gets the most out of audio system, including an LFE channel. For permanently inside the subwoofer. It is 7382A and tailor-fits it to your room. GLM more subs not playing the same signal, e.g.
Page 3
RAM-SW amplifier unit and the 2) Subwoofers are not necessarily required for a 1236A installation as these monitors are already full 7382A subwoofer enclosure. There is a range. For immersive systems, subwoofers can be used to reproduce the LFE channel.
All controls and calibration features included other going to the monitor. subwoofer) and finally to the control in the 7382A subwoofer are set using the network input of the GLM Adapter device Use With GLM Control Genelec Loudspeaker Manager (GLM) (see Figure 1).
(8 in) to ensure functioning of the reflex response. To begin, place the subwoofer port. Multiple Genelec 7382A subwoofers can be near the front wall slightly offset from coupled together in high SPL applications. Flush Mounting the room center line.
558 mm [21 15/16 inch] 293 mm [11 9/16 inch] Figure 5. The dimensions of the 7382A enclosure and the location of the reflex port and input connector Digital Cabling performed by Genelec certified service received, including interference that may Run a signal cable from the THRU AES/ personnel.
Page 7
Level vs Freq (Hz) 7382A 27.8.18 +100 LFE channel Main channels Figure 8. The delay variation of the 7382A 20 30 50 Figure 6. The curves above show the frequency response of the 7382A. Level vs Freq (Hz) 7382A 27.8.18...
Page 12
7382A Operating Manual www.genelec.com Genelec Document D0147R001. Copyright Genelec Oy 6.2018. All data subject to change without prior notice International enquiries: In Sweden please contact In the U.S. please contact: In China please contact: Genelec, Olvitie 5 Genelec Sverige Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the 7382A and is the answer not in the manual?
Questions and answers