Optional Blower Installation - Napoleon GD19-1N Installation And Operating Instructions Manual

44

9.0 OPTIONAL BLOWER INSTALLATION

EN
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
If an optional blower is to be used, the blower must be connected to the main power supply. Route a grounded
14 gauge 2-wire power cable to the junction box and ground. At the point where the cable enters the junction
box, a conduit connector must be provided.
Remove the two screws that secure the control panel to the front of
A.
the unit.
Connect the black and red wires of the wire harness to the prongs
B.
on the blower.
Connect the white and black wires of
C.
the wire harness to the prongs on the
thermodisc.
Place the thermal switch assembly
D.
onto the stud located at the lower left
of the fi rebox and behind the support
bracket.
Connect the wiring for the variable
E.
speed switch.
Insert the blower assembly into the
F.
left side under the fi rebox, slide into
the clip and place onto the same stud
used for the thermal switch assembly.
Secure with the lock washer and wing
nut supplied. Ensure that the blower
does not touch the base of the fi rebox,
any wiring or controls. Ensure that the thermal switch is touching
the wall of the fi rebox.
HINT: Rest the thermal disk assembly forward against the
support bracket.
Place the variable speed switch into position and secure with the
G.
pal nut supplied. Reinstall the control panel and install the variable
speed switch knob.
NOTE: Plug into the receptacle on the right side of the unit.
W415-1351 / 08.29.14
WARNING
!
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
VARIABLE SPEED SWITCH
VARIABLE
SPEED SWITCH
KNOB
BLOWER
51.5
VARIABLE SPEED
SWITCH LOCATION
GS66 WIRING DIAGRAM
WHITE
RED
BLACK
WHITE
WIRE
HARNESS
(included in GS66 kit)
TO POWER SUPPLY
THERMAL
SUPPORT
DISK
BRACKET
ASSEMBLY
BLOWER
ASSEMBLY
CONTROL
PANEL
THERMAL SWITCH
CLIP