Download Print this page

Maintenance And Service - Bosch AL 2204 CV Original Instructions

Quick charger
Hide thumbs Also See for AL 2204 CV:

Advertisement

OBJ_BUCH-190-005.book Page 7 Thursday, September 29, 2011 9:18 AM
Battery Charger
Number of battery cells
Weight according to EPTA-Procedure 01/2003
Protection class
Please observe the article number on the type plate of your battery charger. The trade names of individual battery chargers may vary.
Operation
Starting Operation
Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Charging Procedure
The charging procedure starts as soon as the mains plug of
the battery charger is inserted into the socket and the battery
1 or the power tool with the slid on battery 1 is inserted on the
battery charger. The power tool cannot be switched on during
charging.
Firstly, place the battery 1 as shown in the figure onto the
front of the battery charger ( ) and then press the battery 1
down at the rear ( ). To remove the battery, proceed in re-
verse order.
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see Section "Technical Data".
Meaning of the Indication Elements
Flashing Battery Charge Indicator 2
The charging procedure is signalled by a
flashing battery charge indicator 2.
Continuous Lighting of the Battery Charge Indicator 2
Continuous lighting of the battery
charge indicator 2 indicates that the
battery is fully charged or that the
temperature of the battery is not with-
in the allowable charging temperature range, and cannot be
charged for this reason. The battery is charged as soon as the
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
battery charge indicator 2 indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for
operation.
Bosch Power Tools
AL 2204 CV
kg
Troubleshooting
Causes and Corrective Measures
Cause
Corrective Measure
Continuous lighting of the battery charge indicator 2
No charging procedure possible
Battery not (properly)
Properly insert battery into battery
inserted
charger
Battery contacts con-
Clean the battery contacts (e.g. by
taminated
inserting and removing the battery
several times) or replace the battery
Battery defective
Replace the battery
Battery charge indicator 2 does not light up
Mains plug of battery
Insert mains plug (fully) into the
charger not plugged in
socket outlet
(properly)
Socket outlet, mains
Check the mains voltage; have the
cable or battery charg-
battery charger checked by an au-
er defective
thorised after-sales service agent
for Bosch power tools
Working Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charger.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.

Maintenance and Service

Maintenance and Cleaning
If the replacement of the supply cord is necessary, this has to
be done by Bosch or an authorized Bosch service agent in or-
der to avoid a safety hazard.
If the battery charger should fail despite the care taken in
manufacturing and testing procedures, repair should be car-
ried out by an authorised after-sales service agent for Bosch
power tools.
In all correspondence and spare parts orders, please always
include the 10-digit article number on the type plate of the
battery charger.
After-sales Service and Customer Assistance
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Our customer service representatives can answer your ques-
tions concerning possible applications and adjustment of
products and accessories.
English | 7
AL 2215 CV
4 – 6
4 – 6
0.7
0.4
/ II
/ II
1 609 929 Y67 | (29.9.11)

Advertisement

loading

This manual is also suitable for:

Al 2215 cv