Changing Poly V-Belt; Changing The Transfer Belt - Jet SuperSaw JWSS-10CS Operating Instructions And Parts Manual

Changing Poly V-Belt

Make all machine adjustments or maintenance
with the machine unplugged from the power
source. Failure to comply may cause serious
injury!
1. Disconnect the machine from the power
source, unplug.
2. Lower the blade to its lowest point and tilt to
45°. This will allow easy access to the poly v-
belt.
3. Take the tension off of the belt (A, Fig. 51) by
lifting up on the motor.
4. Remove the belt from the arbor and motor
pulleys.
5. Replace the belt. The weight of the motor and
the torsion spring should apply enough tension
to the belt.

Changing the Transfer Belt

Referring to Figures 52 and 53:
1. Disconnect the machine from the power
source, unplug.
2. Remove the front panel (D) by unscrewing the
lock knob (A), pulling off the handwheel (B),
and removing five pan head screws (C) that
hold the front panel.
3. Remove bolt (F) and pivot assembly up to take
the tension off the belt. Take belt off the upper
pulley. Remove nut (G) and pull off the
assembly.
4. Remove the screw and washer (H) that holds
the shaft (I) in place.
5. Loosen the two setscrews (J) that hold the
timing pulley in place.
6. Pull out the shaft far enough so that you can
remove the timing belt (K).
7. Replace with a new belt and reassemble.
8. Make sure timing pulleys are aligned and
tighten setscrews (J).
9. Make sure tension on the timing belt is enough
so that the belt does not slip. Tighten bolt (F).
26
Figure 51
Figure 52
Figure 53