EDI TSG-416 Service Manual page 94

15. Install new bolts using the sequence shown in
the following 3 steps:

Step 1 - tighten M11 bolts to 29.5 lb.ft.
(40 Nm)

Step 2 - tighten M8 bolts to 11 lb.ft. (15
Nm) + 45

Step 3 - tighten M11 bolts additional
120°
16. Install the chain guide and the tensioner arm
from the top of the engine. Install bolts finger
tight.
TSG‐416 ENGINE
17. Install crankshaft sprocket with key at 12 o'clock
position.
18. Assemble drive chain through chain housing
cavity from top of engine and onto crankshaft
sprocket. Align timing mark with coppered link
on drive chain.
19. Insert camshaft sprocket into chain and
assemble to camshaft. Position camshaft key at
12 o'clock and align timing mark between 2
coppered links on drive chain.
20. Install camshaft sprocket bolt and hydraulic
tensioner finger tight.
02‐50