Advertisement
fast charger.
Installing or removing driver bit or drill
bit
CAUTION
:
Always be sure that the tool i s switched of1
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
0
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period, it may not accept a full charge. This i s a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it
almost completely a couple of times.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
and the battery cartridge is removed before
Switch action
Move the reversing switch lever t o the
"FWD" position for clockwise rotation or
the "REV" position for counterclockwise.
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger t o stop.
When the reversing switch lever is in the
neutral position, the tool will not
s t a r t
even if you pull the trigger.
Trisaer switch
CAUTION :
0
Before inserting the battery cartridge into the tool, always check t o see that the trigger
0
Always check the direction of rotation before drilling.
0
Use the reversing switch lever only when the tool comes to a complete stop. Changing
*When not operating the tool, keep the reversing switch lever in the neutral position.
switch actuates properly and returns to the
"OFF"
Position when released.
the direction of rotation before the tool stops may ruin the
tool.
7
Advertisement
