Cd/Dvd Drive - Dell Precision 350 User Manual

1 drive
2 bracket rails (2)
3 screws (4)
2. Gently slide the drive into place until the tabs securely click into position.
3. Attach the power and floppy-drive cables to the floppy drive.
4. Connect the other end of the floppy-drive cable to the connector labeled "DSKT" on the
1 power cable
2 floppy-drive cable
3 floppy-drive connector
(DSKT)
5. If you are installing a new floppy drive rather than replacing a drive,
6. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
7. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
9. Enter system setup and update the appropriate Diskette Drive A option to reflect the size and capacity of your new floppy drive.
10. Verify that your computer works correctly by running the

CD/DVD Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
1. Shut down the computer through the Start menu.
2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
system
remove the front-panel
Dell Diagnostics.
board.
inserts.