Installation - Miele KM 6304 Operating And Installation Instructions

Preparing the worktop
^ Make the worktop cut-out for one or
more appliances as applicable.
Remember to maintain a minimum
safety distance (see "Safety
clearances").
^ Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
Make sure these materials do not
come into contact with the surface
of the worktop.
This cooktop has a seal underneath it
to keep the cooktop securely in
position. Clamps are not required.
Any gap between the frame and
worktop will reduce with time.
Connecting the mains connection
cable to the appliance
The mains connection cable must
be connected by a suitably qualified
and competent electrician in
accordance with current local and
national safety regulations.
^ Connect the mains connection to the
appliance according to the
connection diagram (see "Electrical
connection").
Installing the cooktop
^ Feed the mains connection cable
down through the cut-out.
^ Place the cooktop centrally in the
cut-out. When doing this, make sure
that the seal of the appliance sits
flush with the worktop on all sides.
Do not use any additional sealant
(e.g. silicone).
If, during installation, you find that the
seals on the corners are not flush
with the worktop, the corner radii
ß R4, can be carefully scribed to fit.
^ Connect the cooktop to the mains.
^ Check that the cooktop works.

Installation

63