GLOBAL ASSISTIVE DEVICES Vibra LITE 12 Instruction Manual page 8

Chronograph Instructions:
1) Press the "MODE" button until "CHRONO" is displayed at the top
of the screen. After approximately two seconds, "0‟00"00 will be
displayed at the bottom of the screen.
If a time other than "0‟00"00 is displayed, press the "ST/STP" button
to stop the timer if it is counting up. When timer is stopped, press
the "SET/RST" button.
2) Press the "ST/STP" to start counting up. The icon located in the
center box on the screen will be flashing.
3) Press the "ST/STP" button to stop the timer and record the
elapsed time.
4) Press the "ST/STP" button to resume timing.
Chronograph Split Timing:
1) Reset the Time Display to zero ("0‟00"00) as noted above.
2) Press the "ST/STP" to start counting up.
3) Pressing the "SET/RST" button will freeze the screen. The
elapsed time can be recorded while the internal timer continues to
count up, but is not displayed.