Reinstall Kick Plate; Complete Installation - KitchenAid KDRS467VSS Installation Instructions Manual

11. When finished adjusting the flame height, put a control
knob back onto the valve stem and turn off the burner.
12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that
need adjustment.
15. Lift up on the control console and set it back into place.
For a proper fit, the flange of the control console must hook
over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
16. Check that the control console is flush with the top edge
of the range.
A
A. Flush with range top
17. Replace the 2 screws on each side of the control console.
18. Replace the control knobs.
19. Replace burner grates.
20. Test the flame by turning the control from LO to HI,
checking the flame at each setting.

Reinstall Kick Plate

1. Align shoulder screw mounting holes with shoulder screws
on range.
2. Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the
front of the range.
3. Reattach screws to the top of the kick plate.
B
A
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
C
D

Complete Installation

1. Check that all parts are now installed. If there is an
extra part, go back through the steps to see which
step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Oven(s)
1. Turn power on.
2. Start a Bake cycle. See the Use and Care Guide for
operating instructions.
If oven(s) does not operate, check the following:
Household fuse is intact and tight or circuit breaker
■
has not tripped.
Electrical supply is connected.
■
See "Troubleshooting" section in the Use and Care
■
Guide.
3. When oven has been on for 10–15 minutes, open the oven
door and feel for heat.
If you do not feel heat or if an error code ("F" followed by
a number plus "E" followed by a number) appears in the
display, turn off the oven and contact a qualified technician.
4. Touch OFF.
To set the clock and other oven functions, refer to the
Use and Care Guide.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the
Use and Care Guide or contact the dealer from whom you
purchased your range.
21