KitchenAid KDRS467VSS Installation Instructions Manual page 5

Parts Supplied
Check that all parts are included:
Anti-tip bracket kit
■
A
A. Anti-tip bracket
B. #8-18 x 1" Phillips head screws (4)
NOTE: Anti-tip bracket must be securely mounted to
subfloor. Thickness of flooring may require longer screws
to anchor bracket to subfloor. Longer screws are available
from your local hardware store. See "Install Anti-Tip
Bracket" section.
Gas pressure regulator
■
Burner grates
■
Burner bases and burner caps
■
Grill grate (on grill models)
■
Wave tray (on grill models)
■
Flame spreader (on grill models)
■
Burner assembly (on grill models)
■
Grease trays (2) (on grill models)
■
Griddle drip tray (on griddle models)
■
Grill drip tray (on grill models)
■
Island trim
■
LP orifice package (W10393255)
■
Conversion label (W10393342)
■
NOTE: The cooktop is manufactured for use with Natural gas.
To convert to LP gas, see the "Gas Conversions" section.
Additional Parts Supplied on Steam-Assist Models
Model W10049700 water filter kit
■
¼" to ¼" water supply union
■
B
Parts Needed
Power supply cord kit:
■
30" (76.2 cm) and 36" (91.4 cm) models – A UL listed
■
40-amp power supply cord kit
48" (121.9 cm) models – A UL listed 50-amp power
■
supply cord kit marked for use with nominal 1³⁄,"
(34.93 mm) diameter connection openings
A UL listed strain relief
■
UL listed wire connectors
■
All models must be installed with a backguard if installing
■
at zero clearance to a combustible back wall surface such
as drywall. Alternatively, zero clearance to a back wall is
acceptable provided the surface of the entire back wall
above the range and below the hood is covered with a
non-combustible material such as tile or stainless steel.
See "Cabinet Dimensions" in the "Location Requirements"
section for installation requirements.
30" (76.2 cm) Adjustable Backguard
■
Order Part Number 8285148
36" (91.4 cm) Adjustable Backguard
■
Order Part Number 8284756
48" (121.9 cm) Adjustable Backguard
■
Order Part Number 8284755
9" (22.9 cm) Backguard for 30" (76.2 cm) Ranges
■
Order Part Number W10115773
9" (22.9 cm) Backguard for 36" (91.4 cm) Ranges
■
Order Part Number W10115776
9" (22.9 cm) Backguard for 48" (121.9 cm) Ranges
■
Order Part Number W10115777
22" (55.9 cm) Backguard with Shelf for 30"
■
(76.2 cm) Ranges
Order Part Number W10225950
22" (55.9 cm) Backguard with Shelf for 36"
■
(91.4 cm) Ranges
Order Part Number W10225949
22" (55.9 cm) Backguard with Shelf for 48"
■
(121.9 cm) Ranges
Order Part Number W10225948
To order, see the "Assistance or Service" section of the Use
and Care Guide.
Additional Parts Needed on Steam-Assist Models
Tubing staples/retainers
■
¼" O.D. flexible codes-approved water supply tubing
■
(to make water connection)
Water connection device (to connect ¼" O.D. tubing to
■
water source). Check local codes for type of connection
required.
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and "Gas Supply Requirements" sections.
It is recommended that all electrical connections be made by
a licensed, qualified electrical installer.
High Altitude Conversion
To convert the cooktop for elevations above 6,560 ft (1999.5 m),
order a High Altitude Conversion Kit.
Part Number W10394296 – LP high altitude
■
Part Number W10394295 – Natural gas high altitude
■
To order, see the "Assistance or Service" section of the Use
and Care Guide.
5